• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > how to set the "LimiterSML" in ADS

how to set the "LimiterSML" in ADS

录入:edatop.com    点击:
Hi,

input signal is more than +5dBm, and I set a limiter, and the target output power should be 0dBm. So I set the Vmax=0.224V, because (0.224)^2/50=1mW=0dBm.

But after simulation, the output power is about -8.3dBm, who can explain this? thanks.

Attached is LimiterSML setting and input output singal power.
And the following from Agilent:

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Load pull simulation in ADS need help
下一篇:URGENT HELP FOR USING ADVANCED SYSTEM DESIGN SIMULATOR (ADS) IN MOBILE WIMAX(802.16e)

ADS培训课程推荐详情>>

  网站地图