• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Load pull simulation in ADS need help

Load pull simulation in ADS need help

录入:edatop.com    点击:
Hi friends,
The first time simulate load pull,a question about the DC block and DC feed components as attached photo,whether i need modify the cap. and RF choke values if i use another device and different frequencics simulated.Or i insert the device into the example directly(why?)?
Thanks,

No..
The values are sufficiently high for RF frequencies ( if they are higher than 100MHz )

Don't modify these values, it's acting as a bias tee. You can measure different devices in different frequency band with the same bias tee.
The simulation result is not depending on these values.

These caps and inductors are large enough. They hardly have any effect on smith chart for high frequency application.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Momentum Optimization Tutorial: ADS 2009
下一篇:how to set the "LimiterSML" in ADS

ADS培训课程推荐详情>>

  网站地图