• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Microstrip in ads

Microstrip in ads

录入:edatop.com    点击:
in ads simulations,i saw that two componts are connected by microstrip,but when i simulate a circuit,i only use a wire.i want to konw,how to represent the wire with a microstrip,how to choose the width and the length of the microstrip between two componts.thanks

please make your question more clear.

anyway if you run ADS and open an schematic page, then you can go to microstrip library and select Mlin and place in the sch and change the w and l to what you want.

ok.
u konw ,in the low frequency PCB,the wire between two components is only a wire,its width and length have little effect on the circuit.but in the RF PCB,we should take them into account,so i want to konw how to choose its width and length?ok?thank u

there are some standard formulae that provide width & length of a microstrip depending on the type of substrate used, the thickness of the copper cladding. These are for higher frequencies. To answer your question, the width of your track will depend on how much dc current is going to flow through.. go to rogers website and they've got a calculator for this purpose. It also accounts for the temperature.

In RF circuits transmission line networks are used to connect circuit stages with certain matching characteristics (microstrip , co planner WG,... ).
No wires are used

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:ADS AND receiver design [hlp]
下一篇:ads drawing inductor

ADS培训课程推荐详情>>

  网站地图