- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
How to simulate a Power Amp for PIdb and gain compression in ADS?
Thanks
It's a C-Band internally matched HEMT GaAs MesFET.Unfortunally it does not have a nonlinear model but s-parameters.in its datasheet some parameters are given but obviously they are not sufficient.
The only thing that you may do " implement that circuit on a board and play with components"...
u can c the p1db and psat gain at p1db (and small signal gain - g1db+1).
so u can use model of "AMP" put those info and good S11 and S22
great job ,if anyone can tell me how to match the gsm power amplifier
By "Load Pull" method. Never use conjugate matching for power amplifiers with high powers.
If you have a simulator and nonlinear model of the output stages' transistors, you can "predict" the optimum load impedance for that amplifier.
If you would use "ready to use" power amplifier for this purpose, the optimum load impedance is already mentioned in its datasheet.
in fact , EUDYNA'device is easy to use,only need to adjust the recomend circuit with a few capacitor, so not worry,just try!
i use the S parameters of the FLL120 AND FLL810IQ-3C to do a power amplifier, only simulate the GAIN and adjust a few capacitor and the result is very good!
just try and not worry!
for beginer TOSHIBA transistor are beter.
when u use fujithsu - u gona have esely osilation
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:s1p ads2003a
下一篇:Diode modelling in ADS
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集