• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > how to simulate quality factor of an spiral inductor in ADS?

how to simulate quality factor of an spiral inductor in ADS?

录入:edatop.com    点击:
how to simulate quality factor of an spiral inductor in ADS?please

Supposed that you have the inductor model...
It's easy: use a Term connected to the inductor and simulate as Spar in your frequency range (don't forget the gnd...)
Use Function: Yin=Port input admittance in Spar library.
Add the following MeasEqn to the schematic: Q=imag(Yin1)/real(Yin1).
You'll find the Q in the dataset to be plotted.

Bye
Mazz

You have a model for spiral inductor under lumped components pallete, and a choice of them in TLINE microstrip pallete. You can work with them in your circuit unless you wont to know exactly and in advance the Q of your inductor. They include loss calculation. You can calculate Q factor as stated above in previous mail. However, when you put your inductor between two ports, you are determining the loaded Q, it should be re-calculated to unloaded (inductor itself is loaded with 50 ohm port impedance, this is not true Q).

There is another method to determine unloaded Q directly - from short circuted inductor (one inductor terminal to ground, the other to 50 OHm port termination), and unloaded Q is determined from reflection.

flyhigh

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Examples for CPW Microstrip Patch Antenna using ADS
下一篇:Why indicate error in running co-simulation in ADS?

ADS培训课程推荐详情>>

  网站地图