• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Help with Oscillator in ADS

Help with Oscillator in ADS

录入:edatop.com    点击:
how to check whether my oscillator has sufficient gain for start up in ADS?

I am working with a colpitts oscillator. I couldnt run the transient simulation as it says lots of warnings when i use the ATC components from ADS.

I used HB analysis, but the manual says it is a steady state simulation. It asks me to test with osctest component. Also, it mentions that the characteristic impedance value of the osctest component may affect the results. I am not sure of wat value to use for the Z value in the osctest component.

Is there any other way to test the start up? Or any rectification for the two methods i have tried?

Please help..

what is the transistor u use , and what is the frequency ? of operation

Khouly

Check the closed loop gain and phase to maintain the oscillation conditions. If they are sufficiently satisfied, the circuit may oscillate.

The best check out method to apply a small transient simulation by forcing a simple pulse over loop path.

I am using a new device which is a SOI MESFET. I have a non linear model for the device. the frequency is 400MHz.

I tried transient simulation but it is giving unreasonable values of KV at the output. There are warnings about the ATC components Imapfreq when i run the transient simulation.

Is the HB analysis only for the steady state?

hi friend
I also faced same problem with ADS
The good solution while working in ADS is
Test your individual components that is apply transiant simulation to each component(say microstrip line) & observe response.
If it is expected directly go for fabrication of oscillator.
best of luck

sure HB analysis is steady state analysis . but it is very efficient in oscillator analysis and phase noise calculation

khouly

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:how to use a .net file for Ads?
下一篇:agilent ads atf-36163

ADS培训课程推荐详情>>

  网站地图