- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
ads user help me
vgs=-.2,how?,i obtain the vol of vgs,it was so small,also any buddy give me the wquastions of calculation of rs and rd
thanks so much
Have a look at hxxp://www.applet.cz/~ulcak/lna.htm. (replace xx -> tt)
Bye
Mazz
hi mazz thanks for reply but i see tha site bofore if u have any paper about supply of atf36077 i will be thanked,how i get vgs=-.2 are u see it is impractical
if you realy need that value (very seriously), you may use 16bit D/A.
Use an active biasing scheme, it will fix the drain current and adapt the VGS to it's purpose!
any buddy have that design or ideas about biasing pls upload it or reply me at pm
regards
There is an IC from infineon for an active bias circuit.
http://www.infineon.com/cgi/ecrm.dll....jsp?oid=13786
i am not sure that you can use -0.2 v or not.
Put a 20 ohm resistor in series with the source lead to ground, DC ground the gate with an inductor, put 1.7 volts on the drain. Assuming a drain current of 10mA, the SOURCE to GROUND voltage is 0.2 volts AND thus the voltage from GATE to SOURCE is -0.2V (since the gate is grounded). The DRAIN to SOURCE voltage will be 1.5V (1.7V - 0.2V). Try it.
Check this out, too:
h**p://www.applet.cz/~ulcak/lna.htm
hi i avoid connect source to bias,here my design ,is that design correct,i apporximate that drain current equal source cuurent and gate ground voltage=-.2 plus voltage drop on source resistance
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:Anybody has good mtr or e-book for ADS beginner?
下一篇:how ads simulate communication system including rf and dsp
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集