• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Help on ADS 2004A - 802.11 system

Help on ADS 2004A - 802.11 system

录入:edatop.com    点击:
Hello to all,
I have working on ADS 2004 for quite some time now.. I have simluated 802.11 related PLL...
I now want to simulate a 802.11b system consisting of a WLAN signal source, a Channel model and a 802.11 receiver/antenna (I will then have a elaborate ckt. after the antenna )at the receiving end... I faced problems on the following things_
1. There are not many antenna designs available in ADS 2004A .. (or I didn't find them). 802.11 receiver is available- but I do need a antenna. Secondly, the available antennas don't seem suitable for my purpose... Any suggestions on your side.. ( I already went through with the manual)
2. The secoond and more pressing problem is that I don't know how distance will come into picture when I model this transmit-receive suystem... I didn't find any distance parameter in the WLAN Channel model...
I would be glad if any one of you could help me out with this...
Thanking you in advance,
Warm regards..
Shantanu...

But your antenna model doesn't really matter. In this simulation, the only thing that the antenna does is convert from electromagnetic radiation to a received voltage, a simple gain should take care of that. I haven't looked at the channel models, but it seems that there should be a distance parameter there, to account for path loss over differring distances.

Dave

the channel model you used may be awgn or multipath model, in your situation you need a path loss model, am I clear?

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:NEED some Designs using striplines & WAVE GUIDES(ADS)
下一篇:ADS layout problem with a gap instead of OSCPORT

ADS培训课程推荐详情>>

  网站地图