Designing X-Band LNA in ADS

i am designing lna with ADS,i have problems since i cann't get tor NFmin the company has mentioned.nither the Sopt.
also i have some problems with matching network . i need a tutorial.any suggestion?
thanks

There is a lot of LNA book in this forum

Hello,

Take a look to the following link:
www.rfic.co.uk
You should find some tutorials related to LNA.
Hope this helps.

regards.

if the company u use thier transistor, didn't mention the NFmin , and the Sopt , u need to measure them in ur company

khouly

there are many book,for example "the microwave transistor amplifier design"

see tutorial on this link posted by BOY.

https://www.edaboard.com/viewtopic.php?p=525177#525177
This will help you in design
Abhishekabs

If you need to design LNA with optimal noise matching (with gamma-optimal) you need to know noise S-parameters for chosen active device. It can be found at the end of S-parameter file. You have to know such information in order to do optimal noise matching.

There are a few words of precaution. Optimal noise matching sometimes can improve the noise figure. This is the true. But with today?s well designed active RF devices it is often not necessary to do. You need to check what mismatch loss you will get with optimal matching versus conjugated matching. Often this loss is bigger than noise figure improvement from optimal matching and therefore such matching is meaningless. And is wider your bandwidth as harder to get optimal noise matching, and as more negative effects from implementation loss.

Next question is about RF system design: is it really shows that such a high noise figure (that requires optimal matching) is necessary? Often external problems (such as real noise picture) and system linearity are limiting actual noise performance so hard that there is no sense to struggle with optimal noise matching.

Best regards

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。