- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
PA simulation error in ADS
How can I fix the problem?
Plz tell me
1) Which analysis u was performing.
2) if u r performing ac analysis then select P1 tone source and give proper power in dBm or in dB.
Harmonic balance simulation.
To simulate the PAE.
what is the source ur using ? , it is a frequency domain power source
try to increase the power level of the source and check if it will work or not
khouly
there is a lot of help and example design in ADS
why not learn step by step
their simulation method and result calcultion method is very good and easy to use.
The circuit and status window message are in the attatching documents
This solution problems happens when the s11_rho increases. Does it affect the simulation result?
PS:
This is the circuit
And problem description
Actually, I use the simplest PA example in ADS. I only substituted the PA part with my PA translated from Spectre.
i checked the schematic of the circuit , what is the use of the controlled sources in ur schematic , they may do the problem
khouly
In ADS, how to translate single-end signal into differential signal? Then,how about differential to single?
I need to consider the load effect on both sides.
PS:
I use the VCVS to ideally transform single-end signal into differential one. I have also tried transformer, but same problem still exists.
yeah , u need a balun , or VCVS can u send the schematic and i will check it
i have checked the circuit well in the left corner that source and the VCVS u use not grounded , place a ground conection
This is the overall circuit. I added gnd,but still doesn't work.
i have simulated the circuit , there is a diode excede the explosion current in ur circuit , this may cause the problem
try to increase the max current paramter in it
khouly
How do u find the diode current? I didn't find that in the status window.
i didn't adjust anything , it is my normal setting , but in the HB check the status make detailed
khouly
Could you fix the problem and tell me where you have changed? Thanks a lot.
i will try , and update u
khouly
--------------------------------------------------------------------------------
i checked the schematic of the circuit , what is the use of the controlled sources in ur schematic , they may do the problem
khouly
PS:
--------------------------------------------------------------------------------
i checked the schematic of the circuit , what is the use of the controlled sources in ur schematic , they may do the problem
khouly
The controlled source is used to model the load effect on the PA output.
SpectreRF use this method to realize single-to-differential transformation
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:Center tapping in ADS
下一篇:required help for simulation in ADS
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集