• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > any help at ADS user

any help at ADS user

录入:edatop.com    点击:
hi guys,i want to design atf36077 with vds=1.5,
vgs=-.2 v i want to calculate the exact s par.
at that condtions ,then calculate the
r resistors of dc simulation,i use appcad
at these condition,my question is
can i change ids to see the change
of s par.at all here my pic,pls any
error reply me

u can do it by parameter sweep , sweep the current and calculate the sparameters but this is valid only if u use the nonlinear model of the transistor

but if u r using the sparameter model u cannot change the current coz the sparametrs model is for a certin bias conditions

The S-Parameters can not be calculated, only measured under the certain conditions. Therefore , S-parameters are given as a list with the information of biasing conditions. You HAVE TO provide the SAME biasing conditions that is already defined to validate your design. Otherwise some errors will obviously come into your design.

In other hands, using nonlinear models to obtain S-Parameters under different biasing conditions WON'T give the SAME S-Parameters, it's sure.
Because S-Parameters are measured under the small signal driving and nonlinear models are NOT the SAME as well as physical behaviour which is neccessary to measure them.

To check S-parameters versus biasing, it's should be either measured or an approximation of nonlinear models should be assumed in tolerance. But this tolerance may be very large, pay attention much.

it is ture i agree with u , bu it can be done just to check

and also it will be different , coz the pakaging effects

but i donot know , is it will vary large or not

big boss

but how we can explain when we simulate s parameters with nonlinear model at the same operating point "DC"
we get a very close result to the s parameter model

i have verfied this with @ds and the deviation is small

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:A problem about the setting of substrate in ADS momentum?
下一篇:Balun problem in ADS, plz help

ADS培训课程推荐详情>>

  网站地图