联合仿真lna 出现如下问题

[upload=1]  [upload=1] Simulation / Synthesis Messages
Warning detected by hpeesofsim during TRAN analysis `SP1'.
    COMPONENT `X4_LNA_schematic_13_1':
       Simulator uses frequency lower than frequency range of Momentum model. The S-parameters are extrapolated.
Warning detected by hpeesofsim during TRAN analysis `SP1'.
    COMPONENT `X4_LNA_schematic_13_1':
       The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values.
Warning detected by hpeesofsim during TRAN analysis `SP1'.
    COMPONENT `X4_LNA_schematic_13_1':
       The model for the Layout Component is reused from the ModelDatabase.
Warning detected by hpeesofsim during SP analysis `SP1'.
    The simulation temperature (25.0 C) is not the same as the IEEE standard
    noise temperature (290 K or 16.85 C) in the noise analysis `SP1'.
    If the simulation temperature is not equal to the IEEE standard temperature,
    then the loss and the noise figure will not agree for a passive circuit.
    The `Temp' parameter on the Options item can be set to 16.85 C to
    eliminate this warning message.
仿真几个小时之后给出这个提示，仿真结果S21为负值，噪声到70多最小噪声也是70多，请教是什么地方错误造成的，非常感谢。

 

你确定线都连好了?

 

我最近仿真也总是出现 这个The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values不知道什么原因啊，坐等高手解答

 

我也出现问样问题了，望解答

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。