how to do optimization in micro waves office

i had made my fyp i.e. designing and fabricaion of millimeter wave detector...but there are some problems i am suffering from..the only soultion to them is to optimise it through m.w. office...kinly some 1 tell me the procedure of doing optimization in micro waves office.

Hello mesohaib,

First set the optimizer Goal , then select the parameters which you want to vary then finally run the Optimizer with default Optimization method...

See the below document on Filter Design & optimization Examples...
http://web.awrcorp.com/content/Downl...75576937972060

If you have problems upload your MWO project file with Goals/specification then I will show how to setup the same...