ADS or Microwave Office variable sweep

I'm trying to do a variable sweep in ADS (or Microwave Office).

I have 6 variables and I want to sweep them over frequency with the same percentage increments. So, variable A*0.9, variable B*0.9 through Variable A*1.1, variable B*1.1 in 1% percent increments (20 data points).

ParamSweep seems to be working only with one variable, and BatchSimController does a swap of all combinations of variables which I don't need.

In ADS, you can sweep over multiple variables, by adding multiple sweep controllers. Define the first sweep controller to run the SP simulation, then define the second sweep controller to run the first sweep controller etc.

Do you mean something like this? In the example below I have both variables WH and LH span over 5 points and what I want to see are 5 curves, not every permutation of WH and LH.

What I want is to simulate circuit when WH=13 & LH=80, next curve when WH=14 & LH=84, etc.

Use "Data Access Component" with Discrete MDIF Format Data File.
Here sweep index using one controler.

See the followings.
http://edadocs.software.keysight.com...DiscreteFormat

http://edadocs.software.keysight.com...ageId=58332036