- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > AWR > AWR学习交流论坛 > Yield sensitivity measurement in AWR Microwave office is not giving any results
Yield sensitivity measurement in AWR Microwave office is not giving any results
录入：edatop.com 点击：
Hi
In the yield analysis example, I am trying to plot YSENS measurement for capacitor and dielectric, but nothing comes up irrespective of whether I select Histogram or rectangular to be the type of the graph. The simulation runs, but nothing appears on the graph.
How do I plot these component sensitivity histograms ?
The project is a simple low pass filter designed in AWR MWO.
cheers
In the yield analysis example, I am trying to plot YSENS measurement for capacitor and dielectric, but nothing comes up irrespective of whether I select Histogram or rectangular to be the type of the graph. The simulation runs, but nothing appears on the graph.
How do I plot these component sensitivity histograms ?
The project is a simple low pass filter designed in AWR MWO.
cheers
Hy,
i have looked at youre example and i must say that for this analyze you must put an Yield Analyze when you simulate.So click the tab Simulate/Yield analysis and put for example 100 Iterations.Than you will see on a Histogram graph the meassurements.
Good luck and if you don't achieve what i explain i will sent you the example.
AWR Microwave Office 培训课程套装，视频教学，帮助您快速学习掌握MWO...
上一篇：AWR Microwave Office and 2N2369A Spice Model
下一篇：mwo awr 2008 antenna gain calculation
