HFSS15: Creating Rectangular Contour Plots

This is an x-y-z graph of results. Any data that you can current plot in 3D (as 3D cartesian or 3D polar) is a candidate for a contour plot.

1. On the Results menu (HFSS menu or right-click on Results on the Project tree), click Create <type> Report, and select Rectangular Contour plot from the report type menu.

The Report dialog appears.

2. In the Context section make selections from the following field or fields, depending on the design and solution type.

a. Solution field with a drop down selection list. This lists the available solutions, whether sweeps or adaptive passes.

b. Geometry field with a drop down selection list. For field and radiated field reports, this applies the quantity to a geometry or radiated field setup.

3. Under the Trace tab Z Component area, specify the information to plot as contours:

a. In the Category list, click the type of information to plot.

b. In the Quantity list, click the value to plot.

c. In the Function list, click the mathematical function of the quantity to plot.

d. The Value field displays the currently specified Quantity and Function. You can edit this field directly.

e. Range Function button -- opens the Set Range Function dialog. This applies currently specified Quantity and Function.

4. On the Trace tab Y (Secondary sweep) lines, specify the information to plot along the y-axis in one of the following ways:

• Select the sweep variable to use from the drop down list.

• If sweeps are available, you can select the browse button to display a dialog that lets you select particular values. The quantity will be plotted against the primary sweep variable listed.

5. On the Trace tab X (Primary sweep) lines, specify the information to plot along the x-axis in one of the following ways:

• Select the sweep variable to use from the drop down list.

• If sweeps are available, you can select the browse button to display a dialog that lets you select particular values. The quantity will be plotted against the primary sweep variable listed.

6. Click New Report.

This creates a new report in Project tree, displays the report with the defined trace, and enables the Add Trace button on the Report dialog.

The function of the selected quantity or quantities will be plotted against the values you specified on an x-y-z graph. The plot is listed under Results in the project tree.When you select the traces or plots, their properties are displayed in the Properties window. These properties can be edited directly to modify the plot.

7. Optionally, add another trace to the plot by following the procedure above, using Add Trace rather than New Report.