- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
辐射边界仿真求助
录入：edatop.com 点击：
各位大佬，我在仿真的屏蔽箱外面套了个空气盒子设置的辐射边界，距离箱体50mm，频率为3G，为啥报错啊：2mm (E:/ANSYS/newSE/2mm/)
HFSSDesign1 (DrivenModal)
[error] Solving adaptive frequency ..., process hf3d error: the boundary (IncPWave1_Rad1) is an internal radiation boundary which HFSS does not support. This can be caused by either improper user assignment, defective geometry pre-processing, or incorrect meshing. Please contact ANSYS technical support. (9:42:38 上午 4月 08, 2022)
求求各位大佬指点
HFSSDesign1 (DrivenModal)
[error] Solving adaptive frequency ..., process hf3d error: the boundary (IncPWave1_Rad1) is an internal radiation boundary which HFSS does not support. This can be caused by either improper user assignment, defective geometry pre-processing, or incorrect meshing. Please contact ANSYS technical support. (9:42:38 上午 4月 08, 2022)
求求各位大佬指点
申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的HFSS视频培训教程。
上一篇：求助：关于HFSS坐标系旋转
下一篇：HFSS,CST电磁仿真案例分享
