- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
FEKO - Mesh dependent on the frequency
录入：edatop.com 点击：
Hi!
I am new to FEKO and since I have to simulate a very big geometry I would like to use MoM and to have a mesh that is frequency dependent, but I don't know how to do it with FEKO. What should I write in the Triangle edge length?I have set the frequency "Linearly spaced discrete points" and I don't know how to refere to those frequencies!
Thanks a lot!
I am new to FEKO and since I have to simulate a very big geometry I would like to use MoM and to have a mesh that is frequency dependent, but I don't know how to do it with FEKO. What should I write in the Triangle edge length?I have set the frequency "Linearly spaced discrete points" and I don't know how to refere to those frequencies!
Thanks a lot!
FEKO has the option to suggest a mesh size depending on your frequency. If your problem electrically large (i.e. compared to wavelength, or in other words in terms of wavelength) then you may split your frequency ranges into smaller pieces, 2:1 or 3:1 bandwidth ratios. So that you don't have to use unnecessarily dense mesh even for smallest frequency.
CST微波工作室培训课程套装，专家讲解，视频教学，帮助您快速学习掌握CST设计应用
上一篇：[FEKO] How can I draw a planar circular spiral with rectangular cross section?
下一篇：FEKO problem with source exitation
