新手请教：FEKO仿真S11怎样增加仿真点数？

刚接触FEKO，不明白为什么每次仿真S11时，仿真范围已经设了1GHz,也选了solution frequency =>specify minimum frequency increment 为101
为什么每次RUN只仿真5次就停止了，请问各位大侠，这样是说明我只仿真了5个点吗?想增加仿真点数应该怎么办?在次多谢

哎，大半年没看见feko软件的仿真界面了

參考手冊： FR CARD
您應該選到這個
Continuous data: Select this item to use an adaptive frequency interpolation technique
to obtain a continuous representation of the results in the
given frequency band (see section 21).
請改選這個
Discrete frequency points: If this item is selected the following parameters are applicable:
• Number of frequency points: For a discrete frequency sweep,
the number of frequency samples must be larger than 1.
• Frequency scale: In this group either Linear or Multiplicative
scaling is selected. If Linear is selected, then consecutive
frequencies differ with a fixed value, i.e. the new frequency
is the previous value plus the frequency increment. If
Multiplicative is selected, then consecutive frequencies differ
by a constant factor, i.e. the new frequency is the previous
value multiplied by the frequency factor.
• Specify by: If Frequency increment / factor is selected, the
user specifies the increment or factor mentioned in the previous
item. This, the number of frequencies and the start
frequency then determine the ending frequency. If Ending
frequency is selected, the user specifies this and the increment
/ factor is calculated.

呀！又是英语……头大