- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
FEKO 运行错误。
录入：edatop.com 点击：
运行过程中出现以下错误，请高手帮我看一下，非常感谢。
Scaling of the geometry with factor SKAL = 1.00000E-02
Surface of all triangles in m*m: 5.41805614
Length of the segments in m: 0.0005
Minimum edge length of triangles in m: 0.000500000024 (edge 306)
Maximum edge length of triangles in m: 0.375809759 (edge 370)
Ratio of the max/min edge length is 751.619482
WARNING 1663: Inhomogeneous segmentation for triangles
Minimum surface area of a triangle in m*m: 1.76776695E-006 (triangle 242)
Maximum surface area of a triangle in m*m: 0.0236434541 (triangle 261)
Ratio of the max/min triangle surface area is 13374.7574
WARNING 33131: Inhomogeneous segmentation for triangles
The segment number 1 has neither a node nor a connection
point. The segment cannot be taken into consideration.
The parameter R1 in the EG card should possibly be changed.
ERROR 180: A segment has neither a node nor a connection point
Aborted: 2011-08-16 17:07:10
Scaling of the geometry with factor SKAL = 1.00000E-02
Surface of all triangles in m*m: 5.41805614
Length of the segments in m: 0.0005
Minimum edge length of triangles in m: 0.000500000024 (edge 306)
Maximum edge length of triangles in m: 0.375809759 (edge 370)
Ratio of the max/min edge length is 751.619482
WARNING 1663: Inhomogeneous segmentation for triangles
Minimum surface area of a triangle in m*m: 1.76776695E-006 (triangle 242)
Maximum surface area of a triangle in m*m: 0.0236434541 (triangle 261)
Ratio of the max/min triangle surface area is 13374.7574
WARNING 33131: Inhomogeneous segmentation for triangles
The segment number 1 has neither a node nor a connection
point. The segment cannot be taken into consideration.
The parameter R1 in the EG card should possibly be changed.
ERROR 180: A segment has neither a node nor a connection point
Aborted: 2011-08-16 17:07:10
刨分不均匀，过密和过疏的地方多，是不是你的模型有非常尖锐的地方呢
偶是刚开始学习，现在需要在EDITFEKO里面实现一个双绞线的建模，完全没有思路啊，能不能帮帮我啊……
请问一下，怎样使网格划分均匀呢， 模型是一个矩形谐振腔，估计只有边缘处比较尖锐吧
