外部调用feko？

搞明白了，可采用命令提示符。具体如下：
输入Syntax: runfeko FILENAME [OPTIONS]
  Filename:              name of the *.pre or *.fek file (without extension)
  Options:
   --feko-lite           execution as FEKO LITE with restrictions, but
                         without protection mechanism
   --version             print the version information and then exit
   --pause               pause at the end until a key is pressed
   --priority x          specification of the priority for the FEKO kernel with
                         x=0..4 as follows: 0=idle, 1=below, 2=normal
                         (default), 3=above 4=high
   -np x                 start of the parallel FEKO version with x processes
   --machines-file m     specification of the name m of the machines file
                         with the node names and the number of CPUs
   --remote-host h       launching of a FEKO process inclusive file transfer
                         on another remote host h (hostname or IP address)
   --execute-prefeko     PREFEKO will always be executed, also when the *.fek
                         file exists already and is newer than the *.pre file
   --no-execute-prefeko  PREFEKO will not be executed, also when the *.fek
                         file is older than the *.pre file
   --adaptfeko-mode      special internal mode used by ADAPTFEKO
   --run-from-gui        special execution mode for the graphical user
                         interface
   --use-job-scheduler   run the parallel FEKO kernel within a queuing system
                         (see documentation which are supported) and obtain the
                         number of parallel processes as well as the host list
                         directly from the respective job scheduler
   -d                    debug mode with some extra output
   --prefeko-options ... all following options will be passed to PREFEKO
   --feko-options ...    all following options will be passed to FEKO
   --adaptfeko-options ..all following options will be passed to ADAPTFEKO
   --runfeko-options ... all following options will be passed again to RUNFEKO
   --mpi-options ...     for parallel FEKO versions all following parameters
                         will be passed to the MPI launcher (e.g. mpirun)