• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > 电子设计 > PCB设计 > Orcad技术问题 > 请教:OrCAD10.5产生Allegro netlist出错

请教:OrCAD10.5产生Allegro netlist出错

录入:edatop.com     点击:
请教高手,下面的错误信息是什么意思呀?
说明:用9.2版OrCAD就没有错误,线路图是用9.2版画的!1
谢谢!

********************************************************************************
*
* Netlisting the design
*
********************************************************************************
Design Name:
D:\orcad\01261125.dsn
Netlist Directory:
D:\orcad\allegro
Configuration File:
D:\Cadence\SPB_15.5.1\tools\capture\allegro.cfg
Spawning... "D:\Cadence\SPB_15.5.1\tools\capture\pstswp.exe" -pst -d "Drcad\01261125.dsn" -n "D:\orcad\allegro" -c "D:\Cadence\SPB_15.5.1\tools\capture\allegro.cfg" -v 3 -j "CB Footprint"
#19 Error   [ALG0013] Conflicting values of following Component Definition properties found on C10 and C1 for part "C0402".
              VALUE
#20 Error   [ALG0013] Conflicting values of following Component Definition properties found on C102 a
nd C1 for part "C0402".
              VALUE
#21 Error   [ALG0013] Conflicting values of following Component Definition properties found on C103 and C1 for part "C0402".
              VALUE
#22 Error   [ALG0013] Conflicting values of following Component Definition properties found on C11 and C1 for part "C0402".
              VALUE
#23 Error   [ALG0013] Conflicting values of following Component Definition properties found on C12 and C1 for part "C0402".
              VALUE
#24 Error   [ALG0013] Conflicting values of following Component Definition properties found on C13 and C1 for part "C0402".
              VALUE
#25 Error   [ALG0013] Conflicting values of following Component Definition properties found on C133 and C1 for part "C0402".
              VALUE
#26 Error   [ALG0013] Conflicting values of following Component Definition properties found on C134 and C1 for part "C0402".
              VALUE
#27 Error   [ALG0013] Conflicting values of following Component Definition properties found on C139
and C1 for part "C0402".
[ 本帖最后由 killerljj 于 2008-3-27 17:44 编辑 ]

把C10 和C1 的属性调出来看看,分析一下才能知道

是不是因为Value不同呀?
如下图所示:





顶起,我也是这个错误

Cadence Allegro 培训套装,视频教学,直观易学

上一篇:ORCAD10.3版本的怎么转成9.23版本可以用的文件
下一篇:进阶问题?

PCB设计培训课程推荐详情>>

  网站地图