- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
spb16.5里怎么出矩形焊盘钻孔
录入：edatop.com 点击：
请教一下，出钻孔文件时怎么出矩形焊盘的文件?我这里出不来，出了一些警告：
Processing route path data ...
WARNING: No route path data was found for processing.
-------------------------------------------------------------
Processing slot hole data ...
WARNING: Can't find NC Route bit file (ncroutebits.txt)！
Using T01 to route ALL route cuts.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
Defaulting to T01 as toolname.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
Defaulting to T01 as toolname.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
Defaulting to T01 as toolname.
OVAL slots routed: 0
RECTANGLE slots routed: 3
Processing route path data ...
WARNING: No route path data was found for processing.
-------------------------------------------------------------
Processing slot hole data ...
WARNING: Can't find NC Route bit file (ncroutebits.txt)！
Using T01 to route ALL route cuts.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
Defaulting to T01 as toolname.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
Defaulting to T01 as toolname.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
Defaulting to T01 as toolname.
OVAL slots routed: 0
RECTANGLE slots routed: 3
搜索了一下论坛，搞定了
建立个ncroutebits.txt文件，里面填上0.01 T01
导入到cam350时，对rou文件要在导入时设置一下，和钻孔时使用的参数一致就可以了。
恭喜！
嗯，谢谢
Cadence Allegro 培训套装，视频教学，直观易学
上一篇：求allgero导出和导入的各种文件的作用和显示内容的说明
下一篇：请问前辈多块板联合工作,想做分析以后,原理图是不是要层次图？
