capture和allgro的交互

有下面一段话，我试了一下，高亮功能正常。按他说的，在allegro中用del命令，在capture中选元件，试一下不行，大家讨论讨论。

Cross Selection with CaptureIf you use Capture to create your schematics, you have the ability to crossprobewith Allegro. There are two methods by which you can performcross-probing between the two systems.First, when you run the Capture netlist program, you enable the OpenBoard in Allegro option. After the netlist has been successfully created,Allegro will automatically be launched and you can perform the crossprobingcommands such as placement, highlighting, and so forth.The second method to perform cross-probing is to use IntertoolCommunication. You can launch both Allegro and Capture manually usingthis mode. To enable Intertool Communication, from Capture, selectOptions > Preferences, select the Miscellaneous tab, and check theEnable Intertool Communication option.Important:Remember that you must first start an Allegro command, such asplace, delete and so forth, BEFORE selecting the object in theCapture schematic. If no Allegro command is active, and you selectan object in Capture, the default command is the Allegro“highlight” command. If the object selected is not yet available,you will get an error message on the Allegro command line.

哦?

在allegro中先用命令比如move,然后在capture中点选任一元件,右键,用allegro select命令,对应的就会在allegro中移动.

以下是引用BILLWANG在2005-1-21 8:27:32的发言：在allegro中先用命令比如move,然后在capture中点选任一元件,右键,用allegro select命令,对应的就会在allegro中移动.试一下！

试了一下，确实是这样的，谢谢了。

不过还有一些不方便的地方，比如我选了两个元件，在capture中右键，则没有了allegro select这个功能了。

这个没有办法,我所知道的cross-probing没有一个可以多选的.包括,capture-powerb,pcad-schematic,protelPCB-SCH,powerlogic-powerpcb,pcad-capture.

呵呵，能选一个也比没有强，再次感谢。

看来能多选是EDA厂商以后版本的事了。

14.2 有没有此功能

protel和dxp好像可以多选，呵呵

顶

一个