• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > CST > CST2013 Help > CST2013: Impedance and Calibration Line

CST2013: Impedance and Calibration Line

录入:edatop.com     点击:

Simulation: Sources and Loads Waveguide Port Define Lines... Add...

Impedance, calibration and polarization lines are currently only available for models with tetrahedral mesh representations.

Mode number

Set the number of the mode here.

Line number

Set the number of the line here.

Line creation pick mode frame

Reverse orientation: Toggle orientation of the line creation mode.

Start/Destination  and destination/start point: The line is created by picking one start point and one endpoint

Start/Destination point and face: The line is created by picking one start point and a face.

Start/Destination point and boundary: The line is created by selecting a boundary from the Boundary drop down list and by picking the start/destination point.

Boundary: This drop down list is only activated if the line creation pick mode is set to Start/Destination point and boundary. Select here the appropriate boundary as start location for the line

OK

Stores the settings and closes this dialog. You are requested to define a line either by numerical input or by using the pick tools. If the line is created successfully the settings are added to the Mode / Impedance / Calibration / Polarization table in the Mode Impedance and Calibration dialog box.

Cancel

Closes this dialog box without performing any further action.

Help

Shows this help text.

 

CST微波工作室培训课程套装,专家讲解,视频教学,帮助您快速学习掌握CST设计应用

上一篇:CST2013: Select Excitation
下一篇:CST2013:  

CST培训课程推荐详情>>

  网站地图