CST2013: Frequency Range Settings

Simulation: Settings Frequency

This dialog box provides everything to define the frequency range of your project.

It is important to know that these settings have some influence on the calculation results, that is why you have to choose Fmin and Fmax properly.

No meshing and therefore no calculation is possible without specifying the frequency range.

Fmin

Enter a valid expression for the lower frequency of a stimulation signal and all signal monitors.

The unit for the frequency setting is specified in the Units dialog box and is displayed in the status bar .

Fmax

Enter a valid expression for the upper frequency of a stimulation signal and all signal monitors.

The unit for the frequency setting is specified in the Units dialog box and is displayed in the status bar .

OK

Performs your settings and leaves the dialog box.

Cancel

Closes this dialog box without performing any further action.

Help

Shows this help text.