- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
CST2013: Parameter Sweep Parameter
Home: Simulation Par. Sweep New Par/Edit
Home: Simulation Start Simulation Par. Sweep New Par/Edit
Home: Simulation Start Simulation Par. Sweep New Par/Edit
Home: Simulation Start Simulation Par. Sweep New Par/Edit
Define a parameter for the sweep.
Name
Here the name of the new parameter is listed. If you have entered the dialog via the New Par... button, you may also specify the name.
Value/From
The value of the parameter if Sweep is disabled, or the first value if it is enabled
Sweep
Enable or disable a sweep for this parameter. If it is disabled, the given parameter value will be fix for the entire sequence.
To
This parameter is enabled only if Sweep is enabled. It specifies the maximum value that the parameter will reach during the sweep.
Samples
This parameter is enabled only if Sweep is enabled. It specifies the number of samples of the parameter for a sequence. It must be at least 2 to allow a simulation for the From and the To parameter values. For a value greater than two, the parameter will change for every step by the amount of To-From/(Steps-1).
OK
Stores the current settings and leaves the dialog box.
Cancel
Closes this dialog box without performing any further action.
Help
Shows this help text.
CST微波工作室培训课程套装,专家讲解,视频教学,帮助您快速学习掌握CST设计应用
上一篇:CST2013: Probe – Decoupling Plane
下一篇:CST2013: Special Integral Equation Solver Parameters
最全面、最专业的CST微波工作室视频培训课程,可以帮助您从零开始,全面系统学习CST的设计应用【More..】
频道总排行
- CST2013: Mesh Problem Handling
- CST2013: Field Source Overview
- CST2013: Discrete Port Overview
- CST2013: Sources and Boundary C
- CST2013: Multipin Port Overview
- CST2013: Farfield Overview
- CST2013: Waveguide Port
- CST2013: Frequency Domain Solver
- CST2013: Import ODB++ Files
- CST2013: Settings for Floquet B