首页 > CST > CST2013 Help > CST2013: Enter Point

CST2013: Enter Point

录入：edatop.com 点击：

Modeling: Shapes... [TAB or SHIFT+TAB]

This dialog box lets you enter a value for a point in the working plane. You may either specify it in a Cartesian or a polar coordinate system. Also, if there was a point that you have had to define before you got into this dialog box, you may specify the coordinates relative to that point.

The dialog entries take over the coordinates at the cursor position on the working plane when the TAB key was pressed. However, if the SHIFT+TAB key was pressed the coordinates are always set to zero.

Mode

Cartesian / Polar: (Not available for all modes) You may choose which coordinate system you want to use to specify the point. See also the example below.

X / Y (U / V) and Radius / Angle: Depending of what mode you have chosen, these two text fields will be called either X/Y (U/V) or Radius/Angle. You may enter the values for these two coordinates here.

Relative (Not available for all modes)

This option is active only, if you had to have to specify another point previously. Then you may decide whether you want to give the coordinates of this point relative to the previous one or not.

Accepts the input and closes the window.

Cancel

Closes this dialog box without performing any further action.

Help

Shows this help text.

Example:

Cartesian coordinates:

Polar coordinates:

This examples shows two steps in the creation of a brick. Imagine you got into this dialog box in order to specify the second point. The first point shall have the coordinates (1,1), the second one (2,2) in Cartesian coordinates.

Now you have got four possibilities to specify the values of the second point:

In Cartesian coordinates with absolute values:
x = 2, y = 2
In Cartesian coordinates with relative values to the first point:
x = 1, y = 1
In polar coordinates with absolute values:
Radius = 2.828, Angle = 45
In polar coordinates with relative values:
Radius = 1.414, Angle = 45

CST微波工作室培训课程套装，专家讲解，视频教学，帮助您快速学习掌握CST设计应用

上一篇：CST2013: List of Selected Faces
下一篇：CST2013: Modify Point Location

CST培训课程推荐详情>>

最全面、最专业的CST微波工作室视频培训课程，可以帮助您从零开始，全面系统学习CST的设计应用【More..】

CST2013: Enter Point

Modeling: Shapes... [TAB or SHIFT+TAB]

This dialog box lets you enter a value for a point in the working plane. You may either specify it in a Cartesian or a polar coordinate system. Also, if there was a point that you have had to define before you got into this dialog box, you may specify the coordinates relative to that point.

The dialog entries take over the coordinates at the cursor position on the working plane when the TAB key was pressed. However, if the SHIFT+TAB key was pressed the coordinates are always set to zero.

CST栏目

频道总排行