- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
s parameter problem on cst 2010
why this is so? tjis create problem in getting the exact result....
What is your center frequency?
How about fixing center frequency in your setup? I think that CST will use the center frequency for meshing. Therefore, if you change it, the result will change a little bit.
For example, your frequency range is 100 - 300 MHz. The center frequency is 200MHz.
So, just change the frequency range like 50 - 350 MHz, and so on.
That error may be due to the step you choose between each run. Example
First run: 1GHz - 3GHz with step 1000 but after that it is rechanged step to 500.
Changing the frequency of simulation leads to new mesh-cells for your structure, so your results can be changed!
申明:网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇:CST MWS Studio and CSTResultReader.dll
下一篇:CST Microwave Studio. Collimator modelling.