• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > CST > CST使用问答 > Using sensitivity analysis in CST

Using sensitivity analysis in CST

录入:edatop.com     点击:
In reference to previous thread:

https://www.edaboard.com/thread296190.html

I, too, have the same issue. I am not getting any parameters listed in the dialog box. Did you solve the problem? If you have any document explaining the procedure to carry out sensitivity analysis, can you kindly share? Thanks.

You should look at the official CST document: "CST MICROWAVE STUDIO - Workflow and Solver Overview" that you can find it in installation directory or simply used the help. The sensitivity analysis is described on page 113. In short, you must define so-called constraints at first and then setup sensitivity analysis.

Good luck

申明网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程

上一篇:Are ideal waveguide port and coaxial feed same in CST?
下一篇:How to design paraboic shape in CST? just the reflector shape

CST培训课程推荐详情>>

  网站地图