CST 2010 Microstripes

Dear all,

I'm facing a problem with CST microstripes...Every time I run the TLM solver, the following error prevents me from getting the scattering parameters...

Error Number 921:Initial modes are used to establish a mode profile to launch into a port. The mode profile is calculated using initial conditions defined inside the initial mode. If initial modes are used theneach initial mode must contain at least one initial, all initials must be inside the initial modes. Check there is a well meshed gap between the conductors in the port...

Does anyone know what does this error mean?

Try to improve the resolution of the mesh.

申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。