CST Axial-ratio vs. freq

hi, everyone. I have a question about the CST MWS. Are there any ways to plot the axial ratio of the antenna at a specified angle as a function of frequency? If so, do I need to setup the far field monitors for the frequencies before the simulation? Thanks.

hi

yes you need to setup the far field frequency monitors for the desired range before the simulation begins. after simulation u can use post processing templates to generate the required figure. i hope it helps

regards

did u get axial ration versus frequency graph in cst ?

I was looking for the same thing. Thanks.

yes,u get it
results-template post processing-far field(broad band)-component(choose axial ratio)

Thanks abdoeng..but this setting is apply before or after simulation?

Dear rfmodeler, Please explain once again how to get the axial ratio vs frequency plot in CST.....I'll be thankful to u

hi, after we get the axial ration graph, how to check whether our antenna is circular linear?

the axial ratio below 3 dB is circular polarized

plz ,,,,,,,,,,, this option not exsist in cst 2011 ?

Hello Friends,
Axial ratio actually gives the ratio of Major axis/ to the minor axis , and its value determines whether our antenna is CP or LP. if the ratio is unity then the Antenna is circularly polarized.

In HFSS we can determine the polarization using the direction of surface current where as in CST MWS the far field tab gives the axial ration direct. The resonant frequency value is to be noted if its less than 3db its circularly polarized or else LP.

We can help you further to plot the axial ration of an antenna at a specified angle as function frequency . for furthe info contact

plz, Opzetlabs ,,, can you give me the steps to plot it, I am using cst2012...thanks

Great Yasir CSt 2012 is amazing . I can specifically help you plotting the axial ratio if you give me an idea as of what work you are doing and what is your requirements.. This would really help

Thanks Opzetlabs , I need " axial ratio " to detemine the polarization states (CP , LP), and the plot with all frequencies is prefered, I can plot the axial ratio vs angle , but I need to plot "Axial-ratio vs freq".

can you plz explain your answer about cst axial ratio plotting?in post processing i found axial ratio but how to draw it against frequency?if any one has sort out this issue plz share.

申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。