• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > CST > CST使用问答 > CST Simulation problem : Not enough longitudinal points for port number 1.

CST Simulation problem : Not enough longitudinal points for port number 1.

录入:edatop.com     点击:
Hi,

I have an error after simulate my antenna by using CST Microwave Studio.

"Not enough longitudinal points for port number 1. The space in front of the port needs to be at least 3 cells long"

I don't understand the error and how to solve. Anyone can help me ?

Hi,
Iam also getting same error. If u found the answer, it will be helpful for me if u share it....

Simulation, the following error

Not enough longitudinal points for port number 1.The space in front of the port needs to be at least 3 cells long.

Some people say that the Internet port widening settings, was not successful.

Others said the port piece of microstrip lines lengthened, was not successful.

Solutions are as follows: When setting the port, first select the port that section of the dielectric substrate of the section, and then click Settings wave port, set the port mode for the PICK. Then his way to set the port to expand. Can.

Another: there is no ground plane and the ground plane of the port settings are different.

With the ground plane, starting from the port just under the bottom surface of the ground plate counting.

The floor is not connected, the port number can be counted starting from below the ground plane, the ground plane that is completely contained inside.

Note: The answer was taken from : " http://jindaodao.blog.sohu.com/155447801.html "

申明网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程

上一篇:CST and HFSS optimisation : variable limitation
下一篇:CST Studio ballast PCB Simulation issues

CST培训课程推荐详情>>

  网站地图