• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > CST > CST使用问答 > CST MWS: S-Parameters

CST MWS: S-Parameters

录入:edatop.com     点击:
I am simulating a coaxial cable in CST MWS and I have the results in S-Parameter form, i.e. Frequency Domain. Now I would like to transform them, FFT, into the Time Domain so that I can look at the reflections from discontinuities. Is there a way to do this in CST MWS, or will have to use additional software? Any help would be greatly appreciated.

Thanks,

Leegit

Leegit,

You can run under template based post processing -> Time Signals -> TDR from S parameter. This will give you impedance vs time which then you may be able to see the effect of discontinuities. ... depending on the frequency range of the S parameters and the distance from the source the discontinuity is.

Whoever can help

My question is: i designed an simple hertz dipole array(ex. 2x2) which i fed ports by discrete port for each element, so i have 4 discrete ports in this example. In the results i received s parameters of 4 results: s1, s2, s3, s4, but they had different results and 02 results of them is ok (in return loss) but the others is not ok. how can i combine those 4 results become one result?
Thank a lot
Minh

申明网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程

上一篇:Performing RCS on a CPW antenna Using CST
下一篇:A problem in setting excitation (plane wave) in CST

CST培训课程推荐详情>>

  网站地图