- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
coaxial connector and coaxil feed design using CST
录入：edatop.com 点击：
I have few questions regarding coaxial connector and coaxial feed design.
1. What type coaxial connector should be used for Microstrip patch when it is fed by probe feed . Can we use normal SMA connector or any special SMA connector available.
2. When designing coaxial feed in simulator (CST or HFSS) what should be the length of the SMA connector below the ground plane. Normally we chose inner and outer diameter of probe feed to match the 50 ohms of the connector. what should be the standard length of the connector below ground. Varying the SMA connector length below the ground plane gives variation in return loss plot in the simulator results.
1. What type coaxial connector should be used for Microstrip patch when it is fed by probe feed . Can we use normal SMA connector or any special SMA connector available.
2. When designing coaxial feed in simulator (CST or HFSS) what should be the length of the SMA connector below the ground plane. Normally we chose inner and outer diameter of probe feed to match the 50 ohms of the connector. what should be the standard length of the connector below ground. Varying the SMA connector length below the ground plane gives variation in return loss plot in the simulator results.
i am having the same problem if you found the answer then please tell me
thanks
申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇：CST 2010 parameter sweep problem. why it gives incorrect labelling?
下一篇：CST human voxel - help needed
