- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Usign Discrete port in CST
录入：edatop.com 点击：
Hi,
I want to model a simple Microstrip line(MS) in CST using discrete port. I had used the Waveguide port it has given me some results i want to compare with the discrete port.
Problem is that When i use a discete port between Ground and Microstrip line it gives me an error "The Port is inside PEC" and solver stops.
My need is to use two ports at the ends of MS Line and assign the Different Impedence to both Ports (like P1=50 phm P2=80 Ohm). This can be used in Impedence matching.
Any other ideas for modeling the same problem are Welcomed and Appreciated.
I want to model a simple Microstrip line(MS) in CST using discrete port. I had used the Waveguide port it has given me some results i want to compare with the discrete port.
Problem is that When i use a discete port between Ground and Microstrip line it gives me an error "The Port is inside PEC" and solver stops.
My need is to use two ports at the ends of MS Line and assign the Different Impedence to both Ports (like P1=50 phm P2=80 Ohm). This can be used in Impedence matching.
Any other ideas for modeling the same problem are Welcomed and Appreciated.
Hi waseemsh,
If you properly define the ends of the ports (properly connected to the ends of conducting layers), then the next possibility of getting this "The Port is inside PEC" error is when a mesh line is not running though the port.
Please try the simulation with a smaller mesh.
If you know to configure "local mesh" try to define a more densed mesh lines where the port is connected.
hope this will be useful,
regards,
申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。
