- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
cst slotline
录入：edatop.com 点击：
Hello
I have a problem with simulation slotline in CST MW 2008. Actually, I want to evaluate impedance of a slotline stub (radial and circular) but face a problem which is that line impedance doesn't depend on frequency how it should be. This obstacle leads wrong results in calculation Z parameters. I tried to drive the line with waveguide port using transient and frequency solvers but the result is the same.
How excite slot line to get adequate results?
I have a problem with simulation slotline in CST MW 2008. Actually, I want to evaluate impedance of a slotline stub (radial and circular) but face a problem which is that line impedance doesn't depend on frequency how it should be. This obstacle leads wrong results in calculation Z parameters. I tried to drive the line with waveguide port using transient and frequency solvers but the result is the same.
How excite slot line to get adequate results?
申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇：How to write CST 2D result field to output?
下一篇：Usign Discrete port in CST
