- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
CST MS : Parameter Sweep : Wrap Phase possible?
录入:edatop.com 点击:
Hi there,
does anybody know the same issue while performing parameter sweeps:
The phase information of an S parameter is always unwrapped and the WRAP tool does not work in my case, even if the results are very close.
For sure I could write a VBA script and search for the minimum phase
etc. but has anybody resolved this before ?
thx a lot,
radioC
does anybody know the same issue while performing parameter sweeps:
The phase information of an S parameter is always unwrapped and the WRAP tool does not work in my case, even if the results are very close.
For sure I could write a VBA script and search for the minimum phase
etc. but has anybody resolved this before ?
thx a lot,
radioC
that problem appear when you use parameters sweep but if you make simulation run after run(changing the variable manually) after every run ,you could wrap your phase
regards
Finally I hit on the following solution :
Copy the entire result of the parameter sweep into
a NEW FOLDER in the conventional S Parameter Result Folder
and CST will do the wrap up job automatically for you.
radiocanada
申明:网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇:Question on CST electric field results
下一篇:cst discrete port