- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
ASK: Farfield approximation in CST MWS
录入:edatop.com 点击:
Hi all!
I'm just curious if it's possible to disable the farfield approximation in farfield display (I know this sentence is a bit misleading :)
I mean the line
Approximation = enabled (kR >> 1)
I've tried to set the reference distance in "Plot mode" but nothing..
Help says:
Reference distance: Set the radius of the virtual sphere for which the farfield is calculated. Available for plot modes e-field / h-field and power pattern.
if I change distance nothing is done with the pattern, only the magnitude is changed.
Please see also the "Farfield View" section in HTML help and look at the table at bottom -> for Radial and Radial phase there's farfield approximation off!
Thanks for any clue!
regards,
eirp
I'm just curious if it's possible to disable the farfield approximation in farfield display (I know this sentence is a bit misleading :)
I mean the line
Approximation = enabled (kR >> 1)
I've tried to set the reference distance in "Plot mode" but nothing..
Help says:
Reference distance: Set the radius of the virtual sphere for which the farfield is calculated. Available for plot modes e-field / h-field and power pattern.
if I change distance nothing is done with the pattern, only the magnitude is changed.
Please see also the "Farfield View" section in HTML help and look at the table at bottom -> for Radial and Radial phase there's farfield approximation off!
Thanks for any clue!
regards,
eirp
Hi Eirp,
if you select E-field or H field as plot mode, you can switch off the "use farfield approximation" under Farfield Plot-> general
Hope this helps,
F.
It helped me a lot! Sorry my blind eyes :)
Thanks! /eirp
PS: reply here if you have relevant comments
申明:网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇:Export Antenna Model from Antenna Magus 5.1 To CST Microwave Studio 2014
下一篇:Cst cylindrical design problem