- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
how to introduce S parameters in CST?
录入:edatop.com 点击:
Hi everybody,
I have to simulate a lumped elements loaded antenna in CST Microwave Studio. The used lumped elemenets are defined by S parameters.
Could CST accept this kind of mixture simualtion?
regards,
Sami
I have to simulate a lumped elements loaded antenna in CST Microwave Studio. The used lumped elemenets are defined by S parameters.
Could CST accept this kind of mixture simualtion?
regards,
Sami
nobody knows?
Can you elaborate a bit more? Is it the generator load? or is it a termination like in a leaky-wave antenna?
You can always go the other way, meaning: Extract the S-parameters of the antenna as a Touchstone file and use it in a microwave circuit software (MWoffice, ADS etc.)
Good luck,
P.
You can do this with CST Design Studio by importing a touchstone file of the lumped elements in Design Studio and co-simulating it with Microwave Studio.
aw
申明:网友回复良莠不齐,仅供参考。如需专业解答,请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇:ADS optimization and CST discrete ports
下一篇:bounding box in cst microwave studio