- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Adding attenuation effect on signal in CST
录入：edatop.com 点击：
Hi all,
I just started using CST and have some silly questions...
As title suggests, I am trying to apply an attenuation on an incoming signal from a port. Instead of drawing a 100m long coaxial cable I was wondering if there is an attenuator of some kind that does the same trick to attenuate the signal. Any thoughts?
Thanks alot!
I just started using CST and have some silly questions...
As title suggests, I am trying to apply an attenuation on an incoming signal from a port. Instead of drawing a 100m long coaxial cable I was wondering if there is an attenuator of some kind that does the same trick to attenuate the signal. Any thoughts?
Thanks alot!
You can add a shorter transmission line with higher losses by using a custom material with higher dielectric constant.
Use schematic symbols (in schematic view not 3d view) like resistors and model your attenuator and after this run em-simulation.
Why?
I mean ... why do you want to include this in the EM simulation?
申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。
上一篇：where is all the field arrows (cst)?
下一篇：CST MW Studio VBA macro advice
