从ADS Model 转到CST 设定上的问题.

大家好 有问题询问先进
我在练习RFID TAG的题目
一开始是用 ADS做练习 结果与实际测试接近
然後再用CST2006 做练习使用从import ---->ADS Model方式呼叫档案
结果都有很多Warning

想请各位帮忙看一下 并指证我哪里设定错误
谢谢各位
======================================================================
Solver cycle: 1
======================================================================
Stimulation at port 1 (mode 1)
--------------------------------------------------------------------------------
Units settings:
Dimensions: um
Frequency:GHz
Time: s
--------------------------------------------------------------------------------
Mesh summary:
< 0.5 :0.3%
< 0.25:0.2%
< 0.1 :0.1%
< 0.05:0.1%
< 0.02:0.0%
Minimal filling: 1.021 %
--------------------------------------------------------------------------------
*** Warning ***
The current settings will propably lead to a very long simulation time.
You may improve the simulation speed by:
1. checking the frequency range and units settings
2. extending the simulation frequency range
3. checking the mesh to avoid very small mesh steps
--------------------------------------------------------------------------------
Subcycle statistics
Number of components in total: 1061396
Number of subcycled components:62875
Number of subcycles: 4
Percentage of overhead: 23.70 %
---
Port: 1
*** Warning ***
Some higher propagating modes at port 1 are not considered in time domain
calculation. This possibly leads to an inaccurate energy balance. Consider to
reduce the port size or decrease the upper frequency limit.
附件里头有
1.CST档案(L4.mod)
2.Solver (solver of L4.txt)
3.从官网下载有关RFID资料

L4.rar

 

1. checking the frequency range and units settings
2. extending the simulation frequency range
3. checking the mesh to avoid very small mesh steps

申明：网友回复良莠不齐，仅供参考。如需专业解答，请学习易迪拓培训专家讲授的CST视频培训教程。